|
<< Click to Display Table of Contents >> Navigation: »No topics above this level« Default scale settings |
When Dispatch detects a change in a definitions Type property it offers to change the Port and Data Packet settings of the definition to the default settings of the selected Type.
If you select Yes, Dispatch will set the following properties:
Serial Port
Baud rate
Data bits
Parity
Stop bits
Time out
Data Packet
Start condition
End condition
Ignore case
Include start/stop condition strings in packet
If you select No, only the Type property will change.
Dispatch knows about the default serial port and data packet settings for each of the available indicator types. These settings have been determined by consulting documentation provided by indicator manufacturers. While it is unlikely the Data Packet settings will need to be changed the Port settings might. These settings may have been changed when the indicator was installed and configured.
There is no guarantee that the default settings will be correct. If you have problems, please contact us or your service technician for assistance.